ABSTRACT
The Covid-19 outbreak has resulted in new patterns of home occupancy, the implications of which for indoor air quality (IAQ) and energy use are not well-known. In this context, the present study investigates 8 flats in London to uncover if during a lockdown, (a) IAQ in the monitored flats deteriorated, (b) the patterns of window operation by occupants changed, and (c) more effective ventilation patterns could enhance IAQ without significant increases in heating energy demand. To this end, one-year's worth of monitored data on indoor and outdoor environment along with occupant use of windows has been used to analyse the impact of lockdown on IAQ. Moreover, using on-site CO2 data, monitored occupancy and operation of windows, the team has calibrated a thermal performance model of one of the flats to investigate the implications of alternative ventilation strategies. The results suggest that despite the extended occupancy during lockdown, occupants relied less on natural ventilation, which led to significantly higher CO2 and PM10 concentrations. However, simple natural ventilation patterns or use of mechanical ventilation with heat recovery proves to be very effective to maintain acceptable IAQ. © International Building Performance Simulation Association, 2022
ABSTRACT
The possibility of unfavorable leakages, especially with infectious diseases, in heat recovery systems in air handling units (AHU) is an essential issue. Typical configurations of AHU are analyzed in this aspect, based on their pressure distribution. It is shown that analyzing only for the design conditions is insufficient and that the changing pressure drops of the air filters due to their nonuniform soiling should be taken into account. The novelty of this paper is in proposed method of considering these leaks in the Wells-Riley model, widely used in the literature for airborne transmission of infectious diseases, including the leakage correction factor fhrleak (outdoor fresh air correction factor) based on EATR (exhaust air transfer ratio). Using the proposed method, for typical rooms, on the example of the SARS-CoV-2 virus and its Delta and Omicron variants, it is shown that considering leaks in heat recovery systems in AHU increases the probability of pathogen transmission. The highest increase in the absolute value of the probability of infection is observed in the single office scenario (4.1%) and in the auditorium with a sick speaker scenario (2.7%). The highest increase in reproduction number is observed in the auditorium with a sick speaker scenario (2.69). Such significant changes in reproduction number, including its change from R < 1.0 to R > 1.0 (auditorium with sick speaker for Delta variant of the virus), are crucial from the point of view of considering event scenarios;they slow down or accelerate the pandemic. © 2023 Elsevier Ltd
ABSTRACT
This work presents an up-to-date overview on the recent developments in the Organic Rankine Cycle (ORC) industry. Information from more than 30 manufacturers, representing a total of almost 2900 projects have been collected and analyzed providing information on trends in the past and the market evolution during the last four years in terms of installed capacity and installed plants divided by application, macro region and manufacturer. At the end of 2020, the cumulated installed capacity of ORCs was 4.5 GW. Since 2016, the overall ORC market increased by 40 % (+1.18 GW) in terms of installed capacity and by 46.5 % (+859) in terms of installed plants. Regarding the capacity increase between 2016 and 2020, the largest increase is due to geothermal application (+972 MW, +45 %) with 74 new plants, while waste heat systems have the largest growth in terms of the number of installed systems (630 plants, +208 %) with an installed capacity of 125 MW. The installed capacity of biomass ORC systems increased by 20 % (69 MW), while the number of installed plants increased by 22 % (77 plants). Additionally, a market survey was conducted, and ten established ORC manufactures contributed their perspective on the ORC market. The results highlight that, despite COVID-19, the current market situation is in good shape and that the majority of the manufacturers have positive expectations concerning the future development. Central and Eastern Europe as well as the ASEAN region are rated as the regions with the highest growth potential. Geothermal energy and small waste heat installations are expected to be the most relevant heat sources for the coming years. © 2023 Elsevier Ltd
ABSTRACT
With the increasing requirements for fresh air supply in buildings after the COVID-19 pandemic and the rising energy demand from buildings, there has been an increased emphasis on passive cooling techniques such as natural ventilation. While natural ventilation devices such as windcatchers can be a sustainable and low-cost solution to remove indoor pollutants and improve indoor air quality, it is not as reliable as mechanical systems. Integration with low-energy cooling, heating or heat recovery technologies is necessary for operation in unfavourable outdoor conditions. In this research, a novel dual-channel windcatcher design consisting of a rotary wind scoop and a chimney was proposed to provide a fresh air supply irrespective of the wind direction. The dual-channel design allows for passive cooling, dehumidification and heat recovery technology integration to enhance its thermal performance. In this design, the positions of the supply and return duct are "fixed” or would not change under changing wind directions. An open wind tunnel and test room were employed to experimentally evaluate the ventilation performance of the proposed windcatcher prototype. A Computational Fluid Dynamic (CFD) model was developed and validated to further evaluate the system's ventilation performance. The results confirmed that the system could supply sufficient fresh air and exhaust stale air under changing wind directions. The ventilation rate of the rotary scoop windcatcher was higher than that of a conventional 8-sided multidirectional windcatcher of the same size. © 2023 The Author(s)
ABSTRACT
Mobilized thermal energy storage (M−TES) is a promising technology to transport heat without the limitation of pipelines, therefore suitable for collecting distributed renewable or recovered resources. In particular, the M−TES can be flexibly used for the emergency heating in the COVID-19 era. Though the M−TES has been commercializing in China, there is not any specific regulation or standard for M−TES systems. Therefore, this paper summarizes and discusses the existing regulations and policies concerning M−TES in the aspects of facility manufacture and operation, road transportation, and financial support and guidance. Furthermore, the suggestions were presented including necessary consensus on the development of M−TES among different departments, consideration of local conditions when drafting or revising regulations and policies, sufficient investment, or subsidy on the R&D of M−TES, and qualification recognition of M−TES companies and staffs.
ABSTRACT
This paper demonstrates the need and potential for using waste heat recovery (WHR) systems from infrared gas radiant heaters, which are typical heat sources in large halls, due to the increasing energy-saving requirements for buildings in the EU and the powerful and wide-spread development of the e-commerce market. The types of gas radiant heaters are discussed and the classification of WHR systems from these devices is performed. The article also presents for the first time our innovative solution, not yet available on the market, for the recovery of heat from the exhaust gases of ceramic infrared heaters. The energy analysis for an industrial hall shows that this solution allows for environmental benefits at different levels, depending on the gas infrared heater efficiency, by reducing the amount of fuel and emissions for domestic hot water (DHW) preparation (36.8%, 15.4% and 5.4%, respectively, in the case of low-, standard- and high-efficiency infrared heaters). These reductions, considering both DHW preparation and hall heating, are 16.1%, 7.6% and 3.0%, respectively. The key conclusion is that the innovative solution can spectacularly improve the environmental effect and achieve the highest level of fuel savings in existing buildings that are heated with radiant heaters with the lowest radiant efficiency.
ABSTRACT
The demand for electricity and power has been increasing with the increase of the population of the world. The Covid-19 Pandemic has affected the way of life of human beings starting last year. The pandemic and economic downturn also affected the electricity demand of the world, but this is only short-term. Once the lockdowns around the world ease and back to normal situation begin, demand for power and electricity shall continue to grow. The century-old Rankine cycle has been the basis for power plants widely used today. However, a modified Rankine cycle known as the Kalina cycle has been proving more efficient than the standard Rankine cycle and might be able to provide the additional power needed in medium and low-temperature sources and waste heat recovery. This paper look into the development of the Kalina cycle and the trends that might be of use for the global electricity requirement.
ABSTRACT
Since the outbreak of the worldwide COVID-19 pandemic, public transportation networks have faced unprecedented challenges and have looked for practical solutions to address the rising safety concerns. It is deemed that in confined spaces, operating heating units (and cooling) in non-re-circulation mode (i. e., all-fresh air mode) could reduce the airborne transmission of this infectious disease, by reducing the density of the pathogen and exposure time. However, this will expectedly increase the energy demand and reduce the driving range of electric buses. To tackle both the airborne transmission and energy efficiency issues, in this paper a novel recovery heat pump concept, operating in all-fresh air mode, was proposed. The novelty of this concept lies in its potential to be applied to already manufactured/in-service heat pump units as it does not require any additional components or need for redesigning the heating systems. In this concept, the cabin exhaust air is directed to pass through the evaporator of the heat pump system to recover part of the waste heat from the cabin and to improve the efficiency of the system. In this paper, a 0D/1D coupled model of a generic single-deck cabin and a heat pump system was developed in the Simulink environment of MATLAB (R2020b) software. The model was run in two different modes, namely the all-fresh air (as a baseline and a recovery heat pump concepts), and the air re-circulation mode (as a conventional heat pump concept with a 50% re-circulation ratio). The performance of these concepts was investigated to evaluate how an all-fresh air policy could affect the performance of the system, as well as the energy-saving potential of the proposed recovery concept. The performance of the system was studied under different ambient temperatures of -5 °C, 0⯰C, and 5⯰C, and for low and moderate occupancy levels. Results show that implementing the all-fresh air policy in the recovery and baseline concepts significantly improved the ventilation rate per person by at least 102% and at most 125%, compared to the air-re-circulating heat pump. Moreover, adopting the recovery concept reduced the power demand by at least 8% and at most 11%, compared to the baseline all-fresh air heat pump, for the selected fan and blower flow rates. The presented results in this paper along with the applicability of this concept to in-service mobile heat pumps could make it a feasible, practical, and quick trade-off solution to help the bus operators to protect people and improve the energy efficiency of their service.
ABSTRACT
The use of Stirling-cycle-based heat pumps in high-temperature applications and waste heat recovery at an industrial scale is of increasing interest due to the promising role in producing thermal energy with zero CO2 emissions. This paper analyzes one such technology as developed by Olvondo Technology and installed at the pharmaceutical company AstraZeneca in Sweden. In this application, the heat pump used roughly equal amounts of waste heat and electricity and generated 500 kW of steam at 10 bar. To develop and widen the use of a high-performance high-temperature heat pump that is both economically and environmentally viable and attractive, various analysis tools such as exergy analysis and life cycle assessment (LCA) can be combined. The total cumulative exergy loss (TCExL) method used in this study determines total exergy losses caused throughout the life cycle of the heat pump. Moreover, an LCA study using SimaPro was conducted, which provides insight into the different emissions and the overall environmental footprint resulting from the construction, operation (for example, 1, 8, and 15 years), and decommissioning phases of the heat pump. The combined results were compared with those of a fossil fuel oil boiler (OB), a bio-oil boiler (BOB), a natural gas-fired boiler (NGB), and a biogas boiler (BGB).